1

I was trying to separate the pads on my hydraulic brake because it was rubbing, but I think I went too far. How do I bring it back? did it mess up the pressure some how?

Improve this question
2
  • 4
    Usually it's just a matter of squeezing the lever enough times for it to self-adjust back where it should be. Is that not doing it?
    – Nathan Knutson
    Commented Mar 26, 2017 at 0:44
  • Have you done anything that might have induced air into the system?
    – Criggie ♦
    Commented Mar 26, 2017 at 5:17

1 Answer 1

Reset to default
2

As Nathan Knutson pointed out in a comment, squeezing the lever should move the pistons and pads inward. Do this with the wheel and rotor installed to avoid popping the pistons out of their holes (that would be messy).

It seems likely that the pads will rub again unless you do something else to correct the problem.

Possible causes of pad-rubbing include:

  • The caliper is not aligned properly with respect to the rotor.
  • The rotor is bent.
  • The pistons are not able to fully retract after the brake is applied. This can be caused by sticky pistons or worn-out piston seals.
  • There's too much fluid in the system. If the brakes worked well since the last bleed, this probably isn't the problem.
Improve this answer
0

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.