I ride through the winter in the Pacific North West and get soaked about every other ride.

What are the best way you've found to dry your shoes?

I've found that stuffing them with wadded up newspaper works well to draw the moisture out, but if I don't swap the paper out every couple of hours, I just get damp newspaper that smells of mildew.

An ideal solution would be passive - in that I would set the shoes up and then just grab the dry shoes a day later for my next ride.

  • Perhaps combining the newspaper approach with some gentle source of heat could remove the moisture from the newspaper, allowing it to whick more water out. Commented Dec 3, 2012 at 18:54
  • 4
    Get a set of shoe covers so that they don't get wet in the first place. (mec.ca/AST/ShopMEC/Cycling/ShoeCovers/PRD~5029-526/…)
    – Kibbee
    Commented Dec 3, 2012 at 20:04
  • 1
    @Kibbee Shoe covers tend not to fit (size 48EU), and given the amount of water I encounter in the forest, I don't expect anything to keep me dry. But those covers look reasonable and affordable. Commented Dec 3, 2012 at 20:39
  • Yeah, they aren't going to work if you step into a deep puddle/river, as they are open on the bottom. But they are decent for the rain. And, with this as well as everything else cycling related, you spend a lot more and get better quality if you so desire.
    – Kibbee
    Commented Dec 3, 2012 at 20:52
  • I lived in Nth Queensland in Australia (tropical climate with monsoonal rains each summer/autumn). As a kid when our shoes got drenched we would put stuff scrunched newspaper in really tight. Overnight the shoes would dry, then you have some dry shoes to wear the next day. I don't recall them ever smelling like mildew, however we would always take the paper out the next morning because we needed them for school. It is still my go to solution when shoes get wet. Better than anything else, and less likely to cause damage to the shoe from heating etc.
    – Dan
    Commented Oct 21, 2014 at 11:08

9 Answers 9


From a theoretical point of view, there are some possible methods to take water out of a fabric object, such as a shoe:

  • "Replacing" the water for another, faster drying liquid and letting it evaporate;
  • Squeezing the water out directly by compression and twisting (not usually adviseable);
  • "Force field" like gravity and centrifugation;
  • Capilary action (which is what the newspaper does);
  • Thermal action (sun, heater);
  • Wind action (free-air, fan).

The last two increase the rate of evaporation, the first by increasing the internal energy of water, the later by reducing the relative humidity of the air layer close to the fabric.

Then (always theoretically) one possible way to dry a shoe quickly would be to force-circulate warm, dry air inside a newspaper filled shoe that has been previously centrifugated/squeezed after being rinsed in warm water with a bit of alchohol.

The problem that still persists is how to actually implement this air heating and circulation without a complicated device or combination of devices...

I use to put newspaper inside as you described, but for the first three stuffings, I squeeze firmly (stepping over if necessary) so that most the moisture is mechanically removed. Then I put extra, dry newspaper and leave the shoes hanging in the open air. Unfortunately, depending on weather conditions, this not always work.

  • 1
    Would Gore-Tex be considered rocket science? ;o) Commented Dec 3, 2012 at 21:43
  • 1
    +1 For your theoretical pont of view. I have used some of these techniques. I hace used a hairdryer, it can be quite fast depending of the shoes, but it's not passive. I have used a fan but it requires some space and a dry warm room.
    – Jahaziel
    Commented Dec 3, 2012 at 23:47
  • 2
    Also, considering smell problems: Smell is caused by bacteria growing and feeding in the humid ambient. Bacteria is present in the dirt, mud, sweat... So if you rinse your shoes, even if they are not completely dry, you can almost eliminate the odor. I have had such times when washing-drying shoes between rides was highly impractical, so I only rinsed them with abundant clean water and used them completely soaked anyway! :P
    – Jahaziel
    Commented Dec 3, 2012 at 23:56
  • 1
    @Jahaziel +1 for the bacteria factor. I have discovered, while touring (in the summer!), that using clothes and shoes wet from clean water is not a big problem, neither regarding smell nor skin damage. The same doesn't apply for sweaty wetness, which contains both bacteria and "food" for bacteria and can cause some chafing... Commented Dec 4, 2012 at 2:29
  • 1
    The choice of shoe helps a lot. Nice "racing" shoes from Sidi or Mavic will tend to have less fabric and padding and more leather/plastic. Also a good idea to remove the insoles and dry them separately to speed things up.
    – Angelo
    Commented Dec 6, 2012 at 19:56

My solution is to wear cycling sandals (I use Shimano SD-66) in combination with neoprene shoe covers.

I find that I'm still toasty warm even when it's very wet and down to 0C/32F. Then when I finish the ride, I can hang up the shoe covers and let the shoes air out and everything generally gets pretty dry for the ride home.

Plus riding in sandals in summer is awesome!


There are a number of products that are referenced as "boot dryers" which would serve your purpose. They are commonly used for ski/snowboard boots but will dry any shoe out efficiently. Know that using these will stink up a whole room like a gym locker room, so use them with discretion in your home.

  • 1
    +1 for the stink factor. That smell is memorable, to say the least.
    – WTHarper
    Commented Dec 3, 2012 at 22:23
  • If you can afford the extra cost, buy an extra pair of shoes. When using the boot dryers you can use the lowest heat setting. This decreases that stiff cardboard shoe feel when they are first worn.
    – mikes
    Commented Dec 3, 2012 at 22:55

I have a Dry Guy Boot dryer which I put my shoes on after I get home to dry them out. The heat really isn't needed, just set the timer to air out my shoes and gloves. They also make a portable one that can be used with a 12-volt car power that works with just one pair of shoes at a time. This is also useful after a long ride where you've been sweating a lot to keep them dry and prevent them from smelling. I use this thing after every ride to keep my shoes fresh, I just set the timer appropriately depending on how moist the shoes are.

<img src="https://dryguy.com/images/DryGuy/drying/WideBody/widebody_1.jpg">

You can probably DIY something like this easily with a large computer case fan and some PVC pipe if you're so inclined, but you need to make sure it's designed so that the water doesn't drip directly on to the fan.

If you don't use a boot dryer, you can fill the shoe cavity with newspaper and that should suck out some of the moisture. You'll want to squeeze as much out as you can in to the first packing and then re-pack the shoes. You'll probably need to re-pack a few times over the course of a day to get them really dry. Placing them in front of a fan or by a heater will help speed up this process.

  • Hi @Benzo. I notice the links have rotted. Are you able to repair them, or summarize?
    – andy256
    Commented Oct 21, 2014 at 10:37
  • Fixed links and images. I mention dry guy boot dryer, but there are several other manufacturers making boot dryers, this is just the one I have and was one of the cheaper ones I found on amazon.
    – Benzo
    Commented Oct 21, 2014 at 14:25

You should acquire a good dryer, the kind with the tray insert that you can set shoes on. Easiest way to dry your shoes every time.

You're in Corvallis though, so there's it's a safe bet for me to wonder if you're in a dorm or apartment that doesn't have a washer and dryer. In this case what I do is prop my wet shoes in front of a space heater ( obviously, making sure that they're not so close that they get too hot ).

  • I like it, though our new dryer didn't come with an insert (the old one had one). Commented Dec 3, 2012 at 21:53

When I ride into the office I use the hair driers in the changing room to kickstart the drying process and then, during the day, I leave them on a ventilation grid close to my desk.

I also use the wadded up newspaper method - but I find that the stream of (dry) air is more effective if available.


If I really had this problem a lot I'd consider buying a boot dryer. It blows air through the boot/shoe to dry it out, and can also be used to dry helmet and gloves.


I've found booties (shoe covers) to be pretty useless if you're cycling over 10 km. Rain will inevitably get in. I have a pair of SPD shoes with removable in-soles. SPD shoes generally have a plastic base which doesn't soak through like fabric materials. Since the insole can be taken out (when you arrive at your office in morning or wherever) the 'wet' parts of the shoe are separated so dry quicker. Wear a good thick pair of socks and pack another for your days work to put on when you arrive.


If you have a regular drier, tie the laces into knots, and close the drier on them to suspend them inside the drier. Turn the drier on high. This came from this post: http://kc-bike.blogspot.com/2008/09/tricks-of-trade-drying-your-grimy-shoes.html?m=1

Also, make sure you check the manual for your cleats. Some manufacturers will void your warranty if you expose your shoes to high heat.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.