4

see update at the bottom

I'm trying to remove my Nexus SG-C6001-8D from its hub shell to grease it. Sadly Shimano's documentation doesn't cover the process of extracting the internals from the hub shell. The info I can find online is mostly for Alfine hubs, where after removing the sprocket on the drive side, you take off a small plastic cover to reveal a large plastic thread, which can be turned with a special tool to take the cover completely off.

In my case though, this doesn't seem to exist - below the sprocket there's only a large, rubber plastic dust cover that doesn't seem to have a thread anywhere and also cannot be removed by hand.

Are Nexus hubs different in that respect, and the cover does not need to be removed to extract the hub from the hub shell? Or is this because I have a belt drive bike, and the process is different than with a traditional chain sprocket?

Alfine

after taking off the sprocket enter image description here

removing the small ring to access the thread enter image description here

the thread enter image description here

My Nexus hub - note the lack of any thread or teeth to unscrew it, unlike the Alfine

enter image description here

update:

I've disassembled the hub to perform regular maintenance (replacing grease). As it turns out, on this model, the dust cover simply pops onto the drive side of the hub and is not threaded. There's no need to take it off before removing the internal hub - simply undo the bearings and push it out from the non-drive side, the cover will come off together with the rest of the assembly.

Improve this question
1
  • 1
    pry the rubber cover off with a tyre lever, see if that lifts it.
    – Noise
    Commented Nov 20, 2021 at 17:00

2 Answers 2

Reset to default
4

(Edit because I was confused by the original pictures)

Here is how Shimano shows that hub going together:

enter image description here

The "Right Hand Dust Cap A W/ Seal" lifts off, and then you remove the left side cone and locknut to remove the hub core ("Internal Assembly").

Improve this answer
2
  • Well, that's the thing - the Alfine seems to have this toothy seal after you remove the plastic ring around it (see 2nd picture), but the Nexus does not seem to have any of this - just one solid rubber cover with no teeth on it and no obvious way to unscrew it.
    – user4520
    Commented Nov 20, 2021 at 16:55
  • @user4520 edited, sorry
    – Nathan Knutson
    Commented Nov 20, 2021 at 20:50
1

This German video at 10:00 shows how to disassemble the Nexus hub. The Nexus hub indeed doesn't have the additional plastic lockring with the outer teeth. You are apparently supposed to hammer the hub out after unscrewing the bearing conus. Make sure there isn't any dust cover left you can pry off.

Improve this answer

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.