2

So I was going to take my wheel off to replace my cassette but last night I gave it my all but could not get the quick release lever to disengaged. I've read to use a pipe for some more leverage but the lever is right next to the frame.

Should I try some PB blaster or anything like that one it? The other side seems to have those plastic caps vs a metal bolt (if that makes sense).

My guess is this wheel hasn't been removing in many years.

Improve this question
3
  • Leverage will get it, or snap something in the process.You are lifting the QR right? not trying to rotate it as-is?
    – Criggie ♦
    Commented May 5, 2016 at 19:30
  • Correct, just trying to lift it. It's hard to get the leverage only cause it's right next to the frame. But I'm thinking maybe a large set of vice grips will work? Just worried about breaking it.
    – Danny
    Commented May 5, 2016 at 19:50
  • 3
    Find something that you can wrap around the quick release so that you can grip it better. Something like a piece or rope or sufficiently thick zip tie should be strong enough, yet still thin enough to slip behind it. Perhaps wear gloves so you don't have to worry about it cutting into your hand.
    – Kibbee
    Commented May 5, 2016 at 20:28

1 Answer 1

Reset to default
6

Best bet with quick releases when they are hard to remove because of the frame in the way is to get a rag, place it against the frame and then use a long-handled screwdriver to pry it up. That works all the time in the bike-shop I work at. Good luck!

EDIT

I should actually say, if you have carbon fiber release levers, be VERY careful not to crack/crush it, otherwise that's gonna have to meet the wheelie bin.

Improve this answer

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.